5″ SATORI MW13P-4 / Paper

Features

  • Vented aerodynamic cast aluminium chassis for optimum strength and
    low compression.
  • Proprietary cone material with EGYPTIAN PAPYRUS™ fibres made
    in-house.
  • Soft low damping rubber surround for optimum transient response.
  • Advanced BIMAX spider for improved linearity.
  • Powerful optimized low distortion neodymium motor system.
  • Non-conducting fibre glass voice coil former for minimum damping.
  • Extended copper sleeve on pole piece for low inductance and reduced
    distortion.
  • CCAW voice coil for reduced moving mass.
  • Long life silver lead wires attached 180° apart for improved stability.
  • Vented pole piece and coil former for reduced compression.
  • Low piston to chassis diameter ratio.
  • Gasket and bolt hole protrusions for reduced coupling to speaker cabinet.

Additional information

Nominal Impedance

4 Ω

DC resistance

Re 3.8 Ω

Voice coil inductance

Le 0.13 mH

Effective piston area

Sd 70 cm2

Voice coil diameter

30.5 mm

Voice coil height

15 mm

Air gap height

5 mm

Linear coil travel (p-p)

10 mm

Magnetic flux density

1.08 T

Magnet weight

0.1 kg

Net Weight

0.78 kg

Free air resonance

Fs 41 Hz

Sensitivity

(2.83 V / 1 m) 89 dB

Mechanical Q-factor

Qms 3.71

Electrical Q-factor

Qes 0.29

Total Q-factor

Qts 0.27

Moving mass incl. air

Mms 7.2 g

Force factor

Bl 4.9 Tm

Equivalent volume

VAS 14.6 liters

Compliance

Cms 2.09 mm/N

Mechanical loss

Rms 0.5 kg/s

Rated power handling

* 40 W

Note

* IEC 268-5, T/S parameters measured on drive units that are broken in.

Downloads

Reviews

There are no reviews yet.

Be the first to review “5″ SATORI MW13P-4 / Paper”

Your email address will not be published. Required fields are marked *