6″ SB17NBAC35-8 / Aluminum
Features
- Vented cast aluminum chassis for optimum strength and low compression
- Geometrically reinforced aluminum cone for optimum piston operation and reduced break-up.
- Soft low damping rubber surround for improved transient response
- Non-conducting fibre glass voice coil former for minimum damping
- Extended copper sleeve on pole piece for low inductance and low distortion
- CCAW voice coil for reduced moving mass
- Long life silver lead wires
- Vented pole piece for reduced compression
Additional information
| Nominal Impedance | 8 Ω |
|---|---|
| DC resistance | Re 5.7 Ω |
| Voice coil inductance | Le 0.15 mH |
| Effective piston area | Sd 118 cm2 |
| Voice coil diameter | 35.5 mm |
| Voice coil height | 16 mm |
| Air gap height | 5 mm |
| Linear coil travel (p-p) | 11 mm |
| Magnetic flux density | 1.0 T |
| Magnet weight | 0.54 kg |
| Net Weight | 1.56 kg |
| Free air resonance | Fs 31.5 Hz |
| Sensitivity | (2.83 V / 1 m) 86.5 dB |
| Mechanical Q-factor | Qms 4.1 |
| Electrical Q-factor | Qes 0.38 |
| Total Q-factor | Qts 0.35 |
| Moving mass incl. air | Mms 12.5 g |
| Force factor | Bl 5.9 Tm |
| Equivalent volume | VAS 45 liters |
| Compliance | Cms 2.3 mm/N |
| Mechanical loss | Rms 0.6 kg/s |
| Rated power handling | * 60 W |
| Note | * IEC 268-5, T/S parameters measured on drive units that are broken in. |
Downloads
Be the first to review “6″ SB17NBAC35-8 / Aluminum”
Reviews
There are no reviews yet.