9½″ SATORI WO24P-4 / Paper
Features
- Hard paper cone for improved piston operation (made in-house)
- Large optimized motor system with under-cut pole piece and dual shorting rings
- Vented aerodynamic cast aluminium chassis for optimum
strength and low compression - Soft low damping rubber surround for optimum transient response
- Linear symmetric suspension design for improved dynamic
performance - Non-conducting fibre glass voice coil former for minimum damping
- Long life silver lead wires attached 180° apart for improved stability
- Vented pole piece for reduced compression
- Low piston to chassis diameter ratio
- Gasket and bolt hole protrusions for reduced coupling to speaker cabinet
Additional information
Nominal Impedance | 4 Ω |
---|---|
DC resistance | Re 3.3 Ω |
Voice coil inductance | Le 0.29 mH |
Effective piston area | Sd 255 cm2 |
Voice coil diameter | 49.5 mm |
Voice coil height | 23 mm |
Air gap height | 6 mm |
Linear coil travel (p-p) | 17 mm |
Magnetic flux density | 1.1 T |
Magnet weight | 1.36 kg |
Net Weight | 3.7 kg |
Free air resonance | Fs 28 Hz |
Sensitivity | (2.83V/1m) 91 dB |
Mechanical Q-factor | Qms 6.7 |
Electrical Q-factor | Qes 0.42 |
Total Q-factor | Qts 0.40 |
Moving mass incl. air | Mms 42 g |
Force factor | Bl 7.6 Tm |
Equivalent volume | Vas 71 liters |
Compliance | Cms 0.77 mm/N |
Mechanical loss | Rms 1.1 kg/s |
Rated power handling | 90 W |
Note | * IEC 268-5, T/S parameters measured on drive units that are broken in. |
Reviews
There are no reviews yet.